Backup of DIY Electronics/USB (No. 1)

[ Front page ]   [ New | List of pages | Search | Recent changes ]

• List of Backups
• View the diff.
• View the diff current.
• View the source.
• Go to DIY Electronics/USB.
  • 1 (2011-02-24 (Thu) 07:45:20)

---

[[ DIY Electronics]]

USB †

Objective †

This section explains how to create an USB Breakout, which is actually an USB Type A (male)-Type A (female) cable. This
type of USB is cable required for examining each signal of USB cable by a logic analyzer or an oscilloscope.

Configuration of USB terminal †

The table below shows the configuration of USB 2.0. The color of each internal wears is predetermined according to
its specification.

How to make USB Type A (male)-Type A (female) cable †

• Requirements
  • A cable, which is met with USB 2.0 standard
  • CK-19
• Instructions
  • Cut the USB 2.0 cable at the appropriate length. It will be cut shorter than expected. (It tends to be longer than really needed.)
  • Assemble CK-19, place each wire of the cable at selected terminal of USB 2.0, and solder each pin and wire.
• Completion

Revision History †

• 2011/2/24 This article is initially uploaded.

   

Site admin: ryuchi

PukiWiki 1.4.7 Copyright © 2001-2006 PukiWiki Developers Team. License is GPL.
Based on "PukiWiki" 1.3 by yu-ji. Powered by PHP 5.2.15. HTML convert time: 0.006 sec.