bc10/serial interface with switches
[
Front page
] [
New
|
List of pages
|
Search
|
Recent changes
]
Start:
[[bc10]]
-Contents
#Contents
* Summary [#r55d3834]
>
Since there is empty space on the original serial interfa...
pushbutton switches are added. The new serial interface i...
connector are directly wired to these switches on the pro...
* Serial interface (with Switch) [#ace38622]
** Example 1 [#lbfb2e0f]
>
This section only discusses how to add several switches o...
has been completed and understood. For the information of...
*** List of Additional Parts [#k1da0460]
>
|Name|Quantity|>|CENTER:Specs|
|~|~|Operation|Contact Rating|
|Toggle switch|CENTER:1|Power on/off|20 ~ 400 mA|
|Pushbutton switch|CENTER:2|Push Button|1 ~ 100 mA|
CENTER:Wires (Recommend 0.26mm diameter single wires for ...
*** How to Assemble [#g489e6de]
>
+Part of serial interface is assembled (but leave the cov...
+Place Toggle and pushbutton switches on the Protoboard.
+The point A of Toggle switch is connected to GND and #28...
is turned on.
+The point A of one pushbutton switch, which is used for ...
circuit, bc10 recognized that USER button is pushed.
+The other pushbutton switch is allocated for RESET. The ...
at J1. When the button is pushed, GND and #22 are short c...
+The connector cover of J1 is fully assembled, then the p...
*** Exterior [#o9dea842]
>
-Whole connector
--&ref(CIMG8279.JPG,,25%);~
-Inside the connector (J1)
--&ref(CIMG8280.JPG,,25%);~
End:
[[bc10]]
-Contents
#Contents
* Summary [#r55d3834]
>
Since there is empty space on the original serial interfa...
pushbutton switches are added. The new serial interface i...
connector are directly wired to these switches on the pro...
* Serial interface (with Switch) [#ace38622]
** Example 1 [#lbfb2e0f]
>
This section only discusses how to add several switches o...
has been completed and understood. For the information of...
*** List of Additional Parts [#k1da0460]
>
|Name|Quantity|>|CENTER:Specs|
|~|~|Operation|Contact Rating|
|Toggle switch|CENTER:1|Power on/off|20 ~ 400 mA|
|Pushbutton switch|CENTER:2|Push Button|1 ~ 100 mA|
CENTER:Wires (Recommend 0.26mm diameter single wires for ...
*** How to Assemble [#g489e6de]
>
+Part of serial interface is assembled (but leave the cov...
+Place Toggle and pushbutton switches on the Protoboard.
+The point A of Toggle switch is connected to GND and #28...
is turned on.
+The point A of one pushbutton switch, which is used for ...
circuit, bc10 recognized that USER button is pushed.
+The other pushbutton switch is allocated for RESET. The ...
at J1. When the button is pushed, GND and #22 are short c...
+The connector cover of J1 is fully assembled, then the p...
*** Exterior [#o9dea842]
>
-Whole connector
--&ref(CIMG8279.JPG,,25%);~
-Inside the connector (J1)
--&ref(CIMG8280.JPG,,25%);~
Page: